PAL-102410 & PAL-200440 | Door/Window Transmitters (With Reset)

PAL-102410 & PAL-200440 | Door/Window Transmitters (With Reset)

PAL-102410 | Door/Window Transmitter with Reed Switch & PAL-200440 | Door/Window Transmitter with Reset Installation Guide

Overview

The PAL-102410 & PAL-200440 Door/Window Transmitters include a built-in, side mounted magnetic reed switch, with a magnet that supports a 5/8” gap.  The PAL-200440 also includes a manual reset button.

PalCare Registration and Learn-In Process (PalCare 2.0)

The Door/Window Transmitter must be registered with PalCare in order to be monitored and supervised.  Each Door/Window Transmitter has a unique factory-programmed identification number/serial number.  
  1. Log into PalCare via your web browser as Administrator.
  2. Click Wizard
  3. Click Update Location Devices
  4. Select the location you would like to assign the Door/Window Transmitter to
  5. Click Add New Device
  6. Click Ready
  7. Press the Reset button on the Door/Window Transmitter before the timer expires
  8. Verify the captured serial number in PalCare matches the serial number sticker on the device
  9. Click OK, Assign Device
  10. Select Door Sensor, Window Sensor, Door Sensor with Reset, or Window Sensor with Reset depending on device type and usage for the Device Use
  11. Select a Location Area if needed, otherwise leave blank
  12. Click Finish
The Motion Detector is now learned in via PalCare.

PalCare Registration and Learn-In Process (PalCare 4.0)

The Door/Window Transmitter must be registered with PalCare in order to be monitored and supervised.  Each Door/Window Transmitter has a unique factory-programmed identification number/serial number.  
  1. Log into PalCare Portal via your web browser at https://portal.palatium.care/
  2. Click Areas
  3. Click the Area you would like to assign the Door/Window Transmitter to
  4. Select the location you would like to assign the Door/Window Transmitter to
  5. Click Devices
  6. Click Attach
  7. Select the following parameters: 
    1. Device Category: Door and Entry Sensors
    2. Device Type: Door Sensor, Door Sensor with Reset, Window Sensor, Window Sensor with Reset (depending on use)
    3. Description: Optional, can be used to describe which door/window the device is attached to
    4. Serial Number: Enter the serial number as shown on the device label
  8. Make sure Alarm Behavior options has the first switch turned on and the rest off.
  9. Click Submit.
The Motion Detector is now learned in via PalCare 4.0.

Installation and Startup

Installation Notes

      • These products are designed to be maintained by professional security technicians.
      • Products are tested for indoor use.
      • All products should be manually tested weekly.

Mounting the Transmitter



1. Mount the bracket on the wall with the screws provided, ensuring room for the magnet where indicated by the mounting directions on the inside of the bracket.

      
2. Mount the magnet so that it is parallel to the transmitter with no more than a 5/8” inch gap between it and the internal contact magnetic reed switch.

3. Clip the transmitter onto the bracket. Hook the catch first, then press the opposite end into place.
      

           
Alert
When disposing of this device or depleted batteries, please do so in accordance with federal, state and local regulations.




    • Related Articles

    • PalCare Mobile for Android Install and Setup Guide

      PalCare Mobile for Android Install and Setup Guide Installing PalCare Mobile via the Play Store Open the Google Play Store on your device and search for "PalCare Mobile" Alternatively, click this link: ...