How to Program an Apollo Gold Pager (ALA-25 & AP-700)

How to Program an Apollo Gold Pager (ALA-25 & AP-700)

Apollo Pager Programming Guide
ALA-25 & AP-700



1) Remove the battery.  Re-insert battery while holding down button 3 until password or frequency appears, then let off button 3.
      The password will be either "0000" or "2095"
2) If password is shown, press button 4 one time until the frequency is displayed on the screen.  Press button 2 to select the digit to change on the screen.  Press button 3 to change the desired digit.  Repeat until desired frequency is set (467.8000 default).  Use button 2 to scroll over to WB or NB and set to desired bandwidth by pressing button 3 (NB default).
3) Press button 4 one time until capcode is displayed on the screen.  First verify that the desired capcode is set to "ON", then using button 2, scroll through the digits to set the correct capcodes using button 3 until the desired code is set.  Also verify the last four letters are set to "AAAA".
4) Continue pressing button 4 to set up to 6 different capcodes if needed.  Use the same procedure from step 3 if additional capcodes are needed.
5) Press button 4 until baud = is displayed on the screen.  Press button 3 until desired baud is displayed (512 default).
6) Press button 4 until modify password is displayed (0000 default). Using button 2 to scroll through digits and button 3 to set the digits if desired.
7) Press button 4 until adjust contrast is displayed.  This can be changed if desired, however the default is 5.
8) Pressing button 4 one more time will display pass.  The pager will then restart and display the time and date.

    • Related Articles

    • How to Program an Apollo AP-900 Pager

      Apollo Pager Programming Guide AP-900 1) Remove the battery. Re-insert battery while holding down button 5 until PASSWORD or FREQUENCY appears, then let off button 5. The password will be "0000" 2) If password is shown, press button 6 one time until ...

    • Programming a Device into a Four-Zone Add-On Receiver

      To program a new button in, you'll need to know which transmitter slots are in use and which you want to program. The below instructions will program the transmitter into slot 1. Programming steps: 1) Remove the cover from Add-On Receiver 2) On the ...

    • PAL-109110 | Motion Detector for Movement Alert (EN1262HT)

      PAL-109110 | Motion Detector for Movement Alert Installation Guide Overview The EN1262HT high traffic motion detector solves the battery limitation problems of motion sensors in commercial applications through an intelligent sleep timer and low ...

    • PAL-203000 & PAL-203030 | PalCare AiO Station Pull Cord and Call Cord

      AIO stands for All-in-One. The AIO device functions as a pull cord, alert button, check-in button, rounds button, and assist button. Also available with a plug in call cord. PAL-203000 - All-In-One Station - Standard Pull Cord Functionality AiO ...

    • PAL-204000 & PAL-204040 | PalCare AiO Station Pull Cord and Call Cord

      AIO stands for All-in-One. The AIO device functions as a pull cord, alert button, check-in button, rounds button, and assist button. Also available with a plug in call cord. PAL-204000 - All-In-One Station Advanced - Standard Pull Cord Functionality ...