How to Program an Apollo AP-900 Pager

How to Program an Apollo AP-900 Pager

Apollo Pager Programming Guide
AP-900



1) Remove the battery.  Re-insert battery while holding down button 5 until PASSWORD or FREQUENCY appears, then let off button 5.
      The password will be "0000"
2) If password is shown, press button 6 one time until the frequency is displayed on the screen.  Press buttons 1 and 3 to select the digit to change on the screen.  Press buttons 2 and 4 to change the desired digit.  Repeat until desired frequency is set (467.8000 default).  Use button 3 to scroll over to WB or NB and set to desired bandwidth by pressing button 3 (NB default).
3) Press button 6 one time until capcode is displayed on the screen.  First verify that the desired capcode is set to "ON", then using buttons 1 and 3, scroll through the digits to set the correct capcodes using buttons 2 and 4 until the desired code is set.  Also verify the last four letters are set to "AAAA".
4) Continue pressing button 6 to set up to 8 different capcodes if needed.  Use the same procedure from step 3 if additional capcodes are needed.
5) Press button 6 until baud = is displayed on the screen.  Press buttons 2 or 4 until desired baud is displayed (512 default).
6) Press button 6 until modify password is displayed (0000 default). Using buttons 1 and 3 to scroll through digits and buttons 2 and 4 to set the digits if desired.
7) Press button 6 until adjust contrast is displayed.  This can be changed if desired, however the default is 5.
8) Pressing button 6 one more time will display pass.  The pager will then restart and display the time and date.

    • Related Articles

    • How to Program an Apollo Gold Pager (ALA-25 & AP-700)

      Apollo Pager Programming Guide ALA-25 & AP-700 1) Remove the battery. Re-insert battery while holding down button 3 until password or frequency appears, then let off button 3. The password will be either "0000" or "2095" 2) If password is shown, ...
    • Programming a Device into a Four-Zone Add-On Receiver

      To program a new button in, you'll need to know which transmitter slots are in use and which you want to program. The below instructions will program the transmitter into slot 1. Programming steps: 1) Remove the cover from Add-On Receiver 2) On the ...
    • Send a Message to Pagers (Video)

    • PalCare Mobile Deployment Prerequisites

      Just a few notes and prerequisites before we deploy PalCare Mobile at your community: PalCare Mobile can be installed on iOS devices and Android devices Please have PalCare Mobile installed on the devices ahead of time iPhone Link: ...
    • PalCare Mobile for Android Install and Setup Guide

      PalCare Mobile for Android Install and Setup Guide Installing PalCare Mobile via the Play Store Open the Google Play Store on your device and search for "PalCare Mobile" Alternatively, click this link: ...